96 | 802.1Xw w w . d e l l . c o m | s u p p o r t . d e l l . c o m To configure a maximum number of re-authentications:FTOS(conf-if-Te-0/0)#dot1x reauthentication interval 7200FTOS(conf-if-Te-0/0)#dot1x reauth-max 10FTOS(conf-if-Te-0/0)#do show dot1x interface TenGigabitEthernet 0/0802.1x information on Te 0/0:-----------------------------Dot1x Status: EnablePort Control: FORCE_AUTHORIZEDPort Auth Status: UNAUTHORIZEDRe-Authentication: EnableUntagged VLAN id: NoneTx Period: 90 secondsQuiet Period: 120 secondsReAuth Max: 10Supplicant Timeout: 30 secondsServer Timeout: 30 secondsRe-Auth Interval: 7200 secondsMax-EAP-Req: 10Auth Type: SINGLE_HOSTAuth PAE State: InitializeBackend State: InitializeAuth PAE State: InitializeBackend State: InitializeConfiguring TimeoutsIf the supplicant or the authentication server is unresponsive, the authenticator terminates theauthentication process after 30 seconds by default. This amount of time that the authenticator waits for aresponse can be configured.To terminate the authentication process due to an unresponsive supplicant:Step Task Command Syntax Command Mode1 Configure the maximum number oftimes that the supplicant can bereauthenticated.dot1x reauth-max numberRange: 1-10Default: 2INTERFACEStep Task Command Syntax Command Mode1 Terminate the authentication process due to anunresponsive supplicant.dot1x supplicant-timeout secondsRange: 1-300Default: 30INTERFACE
