Routing Information Protocol (RIP) | 853Configuring RIPv2 on Core 2Figure 40-8. Configuring RIPv2 on Core 2Core 2 OutputThe screenshots in this section are:• Figure 40-9: Using show ip rip database command to display Core 2 RIP database• Figure 40-10: Using show ip route command to display Core 2 RIP setup• Figure 40-11: Using show ip protocols command to display Core 2 RIP activityFigure 40-9. Example of RIP Configuration Response from Core 2Core2(conf-if-gi-2/31)#Core2(conf-if-gi-2/31)#router ripCore2(conf-router_rip)#ver 2Core2(conf-router_rip)#network 10.200.10.0Core2(conf-router_rip)#network 10.300.10.0Core2(conf-router_rip)#network 10.11.10.0Core2(conf-router_rip)#network 10.11.20.0Core2(conf-router_rip)#show config!router ripnetwork 10.0.0.0version 2Core2(conf-router_rip)#Core2(conf-router_rip)#end00:12:24: %RPM0-P:CP %SYS-5-CONFIG_I: Configured from console by consoleCore2#show ip rip databaseTotal number of routes in RIP database: 710.11.30.0/24[120/1] via 10.11.20.1, 00:00:03, GigabitEthernet 2/3110.300.10.0/24 directly connected,GigabitEthernet 2/4210.200.10.0/24 directly connected,GigabitEthernet 2/4110.11.20.0/24 directly connected,GigabitEthernet 2/3110.11.10.0/24 directly connected,GigabitEthernet 2/1110.0.0.0/8 auto-summary192.168.1.0/24[120/1] via 10.11.20.1, 00:00:03, GigabitEthernet 2/31192.168.1.0/24 auto-summary192.168.2.0/24[120/1] via 10.11.20.1, 00:00:03, GigabitEthernet 2/31192.168.2.0/24 auto-summaryCore2#
