4–NVM Express over Fibre ChannelHost Setup112 CU0354604-00 PExample: nvme list CommandThe following example of a portion of the nvme list output shows theFC-NVMe attached targets.Node SN Model Namespace Usage Format FW Rev------- ------------------- -------- ---- ---- ----------------------- --------- -----------nvme0n1 00-200100110dd89300 SANBlaze VLUN P3T0 1 67.11 MB / 67.11 MB 512 B + 0 B V8.x-devnvme1n1 00-200000110dd89200 SANBlaze VLUN P2T0 1 67.11 MB / 67.11 MB 512 B + 0 B V8.x-devnvme2n1 00-200000110d4d1300 SANBlaze VLUN P0T0 1 67.11 MB / 67.11 MB 512 B + 0 B V8.x-devVerifying in WindowsIn Windows, verify that the target devices are available by issuing theqaucli –t command. For example:qaucli -t 0 (HBA instance 0)Using config file: C:\Users\Administrator\qaucli.cfgInstallation directory: C:\Users\AdministratorWorking dir: C:\Users\Administrator------------------------------------------------------------------------------HBA Instance 0: QLE2692Port 1 WWPN 21-00-00-24-FF-8F-E3-9A PortID 01-21-00Link: Online (FEC)------------------------------------------------------------------------------Path : 0Target : 0Device ID : 0x83Product Vendor : NVMeProduct ID : SANBlaze VLUN P2Product Revision : -devSerial Number : 6001_10d0_0247_2600_0302_0000_929d_14c6.Node Name : 20-02-00-11-0D-47-26-00Port Name : 20-02-00-11-0D-47-26-00Port ID : 01-1B-00Product Type : NVME Disk (Ensure that this shows as an FC-NVMe target.)LUN Count(s) : 51Status : Online------------------------------------------------------------