3–Fibre Channel ConfigurationConfiguring Boot Devices45 CU0354604-00 PConfiguring Persistent Binding with NoninteractiveQConvergeConsole CLITo bind a selected target to a specific adapter using the noninteractive mode ofQConvergeConsole CLI, issue the following command:# qaucli -pr fc -p ( instance> | wwpn>) ( wwnn> wwpn> port id> id>)Where:For more information, refer to the section about Fibre Channel noninteractivecommands in the User’s Guide—QConvergeConsole CLI (part numberSN0054667-00).Configuring Boot DevicesUse QConvergeConsole or Fast!UTIL to configure boot devices: Configuring Boot Devices with QConvergeConsole GUI Configuring Boot Devices with Interactive QConvergeConsole CLI Configuring Boot Devices with Noninteractive QConvergeConsole CLI Configuring Boot Devices with the BIOSConfiguring Boot Devices with QConvergeConsole GUIFor information about configuring boot devices with QConvergeConsole GUI,refer to the topics about HBA parameters, viewing or modifying port parameters,and boot device selection in the QConvergeConsole Help.Configuring Boot Devices with InteractiveQConvergeConsole CLIOn the Fibre Channel Adapter Configuration menu, select Boot DevicesConfiguration to open the Boot Device Settings menu with options to view andconfigure boot devices.hba instance = Adapter number (use the -g command to find)hba wwnn = Worldwide node name of the adapterhba wwpn = Worldwide port name of the adaptertarget wwnn = Worldwide node name of the targettarget wwpn = Worldwide port name of the targettarget port id = Port ID of the targettarget id = ID to which the target is bound
