3–Fibre Channel ConfigurationUsing Fast!UTIL for Custom Configuration40 CU0354604-00 PRestore Default SettingsThe Restore Defaults option restores the BIOS settings back to default.Raw NVRAM DataThe Raw NVRAM Data option displays the 2600 Series Adapter’s NVRAMcontents in hexadecimal format. This option is a QLogic troubleshooting tool; youcannot modify the raw NVRAM data.Advanced Adapter SettingsOn the Configuration Settings menu in Fast!UTIL, select Advanced AdapterSettings. Table 3-3 describes the default settings for the 2600 Series Adapters.NOTESystem BIOS compatibility: To boot from a QLogic host 2600 Series Adapterin a computer system with a multiboot system BIOS, the 2600 SeriesAdapter must be included in the list of bootable devices in the system’s Bootmenu.Table 3-3. Advanced Adapter SettingsSetting Values Default DescriptionLUNs perTarget0, 8, 16, 32,64, 128,256128 This setting specifies the number of LUNs supported pertarget if the target does not support the Report LUN com-mand. Multiple LUN support is typically for redundant arrayof independent disks (RAID) boxes that use LUNs to mapdrives.Enable LIPResetYes, No No This setting determines the type of loop initialization pro-cess (LIP) reset used when the OS initiates a bus reset rou-tine as follows: Yes = The driver initiates a global LIP reset to reset thetarget devices. No = The driver initiates a global LIP reset with full login.Enable LIPFull LoginYes, No Yes When this setting is Yes, the 2600 Series Adapter’s reducedinstruction set computer (RISC) controller logs in to all portsafter any LIP.EnableTargetResetYes, No Yes When this setting is Yes, the drivers issue a Target Resetcommand to all devices on the loop when a SCSI Bus Resetcommand is issued.LoginRetryCount0–255 8 This setting specifies the number of times the software triesto log in to a device.
