3–Fibre Channel ConfigurationConfiguring Fibre Channel Driver Parameters53 CU0354604-00 PConfiguring Fibre Channel Driver ParametersUse QConvergeConsole GUI, CLI, or VMware plug-in to configure Fibre Channeldriver parameters: Configuring Fibre Channel Driver Parameters with QConvergeConsole GUI Configuring Fibre Channel Driver Parameters with InteractiveQConvergeConsole CLI Configuring Fibre Channel Driver Parameters with NoninteractiveQConvergeConsole CLI Configuring Fibre Channel Driver Parameters with QConvergeConsoleVMware vCenter Server Plug-inConfiguring Fibre Channel Driver Parameters withQConvergeConsole GUIRefer to the topics about HBA parameters and viewing or modifying portparameters in the QConvergeConsole Help for information.Configuring Fibre Channel Driver Parameters with InteractiveQConvergeConsole CLITo configure Fibre Channel driver parameters using interactiveQConvergeConsole CLI:1. On the Fibre Channel Adapter Configuration menu, select HBAParameters.2. On the port menu, select a port to open the HBA Parameters menu.3. On the HBA Parameters menu, select Configure HBA Parameters toopen the Configure Parameters menu with options to configure connectionoptions, data rate, frame size, hard loop ID, loop reset delay, BIOS, FibreChannel tape support, operation mode, interrupt delay timer, login retrycount, port down retry count, LIP full login, link down time-out, target reset,LUNS per target, and receive out-of-order frames.For more information, refer to the section about the Fibre Channel interactivecommands in the User’s Guide—QConvergeConsole CLI (part numberSN0054667-00).
