3–Fibre Channel ConfigurationConfiguring Selective LUNs54CU0354604-00 PConfiguring Fibre Channel Driver Parameters withNoninteractive QConvergeConsole CLITo configure driver settings, issue the following command:#qaucli -pr fc -fs ( | ) {( |alias>)value>}Where:For more information, refer to the section about the Fibre Channel noninteractivecommands in theUser’s Guide—QConvergeConsole CLI(part numberSN0054667-00).Configuring Fibre Channel Driver Parameters withQConvergeConsole VMware vCenter Server Plug-inFor details on how to configure the Fibre Channel driver parameters using theQConvergeConsole plug-in, see theUser’s Guide—QConvergeConsole Plug-insfor VMware vSphere(part number SN0054677-00).Configuring Selective LUNsThe QConvergeConsole GUI cannot be used for configuring selective LUNs.To configure selective LUNs with the interactive QConvergeConsole CLI, refer tothe section about the Fibre Channel interactive commands in theUser’s Guide—QConvergeConsole CLI(part number SN0054667-00).To configure selective LUNs with the noninteractive QConvergeConsole CLI, referto the section about the Fibre Channel noninteractive commands in theUser’sGuide—QConvergeConsole CLI(part number SN0054667-00).hba instance= Adapter number (use the-gcommand to find)hbawwpn= Worldwide port name of the adapterparamname= Name of the parameterparamalias= Alias of the parameterparamvalue= New value of the parameter
