IGMP Snooping Commands 197ip igmp snooping host-time-outThe ip igmp snooping host-time-out Interface Configuration mode command configures the host-time-out. If an IGMP report for a Multicast group was not received for a host-time-out period from a specificport, this port is deleted from the member list of that Multicast group. Use the no form of this commandto reset to default host-time-out.Syntax• ip igmp snooping host-time-out time-out• no ip igmp snooping host-time-out• time-out — Host timeout in seconds. (Range: 60 - 2147483647)Default ConfigurationThe default host-time-out is 260 seconds.Command ModeInterface Configuration (VLAN) mode.User Guidelines• The timeout should be at least greater than 2*query_interval+max_response_time of the IGMProuter.ExampleThe following example configures the host timeout to 300 seconds.ip igmp snooping mrouter-time-outThe ip igmp snooping mrouter-time-out Interface Configuration mode command configures themrouter-time-out. The mrouter-time-out command is used for setting the aging-out time after Multicastrouter ports are automatically learned. Use the no form of this command to configure the defaultmrouter-time-out.Syntax• ip igmp snooping mrouter-time-out time-out• no ip igmp snooping mrouter-time-out• time-out — mrouter timeout in seconds (Range: 1 - 2147483647)Console (config)# interface vlan 2Console (config-if)# ip igmp snooping host-time-out 3005400_CLI.book Page 197 Wednesday, December 17, 2008 4:33 PM