230 IP Addressing CommandsSyntax• ipv6 host name ipv6-address1 [ipv6-address2...ipv6-address4]• no ipv6 host name• name — Name of the host. (Range: 1 - 158 characters)• ipv6-address1 — Associated IPv6 address. The address is specified in hexadecimal using 16-bitvalues between colons. When the IPv6 address is a Link Local address (IPv6Z address), theoutgoing interface name must be specified. Refer to the usage guidelines for the interface namesyntax.• ipv6-address2-4 (optional) — Addition IPv6 addresses that may be associated with the host’s nameDefault ConfigurationNo host is defined.Command ModeGlobal Configuration mode.User Guidelines• The IPv6Z address format: <ipv6-link-local-address>%<interface-name>– interface-name — vlan<integer> | ch<integer> | isatap<integer> | <physical-port-name> | 0– integer — <decimal-number> | <integer><decimal-number>– decimal-number — 0 | 1 | 2 | 3 | 4 | 5 | 6 | 7 | 8 | 9– physical-port-name — Designated port number, for example g1.ExampleThe following example defines a static host name-to-address mapping in the host name cache.ipv6 neighborThe ipv6 neighbor Global Configuration mode command configures a static entry in the IPv6 neighbordiscovery cache. Use the no form of this command to remove a static IPv6 entry from the IPv6 neighbordiscovery cache.Console (config)# ipv6 host ABC fe80::11 fe80::225400_CLI.book Page 230 Wednesday, December 17, 2008 4:33 PM
