Address Table Commands 95Address Table Commandsbridge addressThe bridge address VLAN Interface Configuration mode command adds a static MAC-layer stationsource address to the bridge table. To delete the MAC address, use the no form of the bridge addresscommand (using the no form of the command without specifying a MAC address deletes all staticMAC addresses belonging to this VLAN).Syntax• bridge address mac-address {ethernet interface | port-channel port-channel-number} [permanent |delete-on-reset | delete-on-timeout | secure]• no bridge address [mac-address]• mac-address — A valid MAC address in the format of xx:xx:xx:xx:xx:xx.• interface — A valid Ethernet port.• port-channel-number — A valid port-channel number.• permanent — The address can only be deleted by the no bridge address command.• delete-on-reset — The address is deleted after reset.• delete-on-timeout — The address is deleted after "age out" time has expired.• secure — The address is deleted after the port changes mode to unlock learning (no portsecurity command). This parameter is only available when the port is in learning lockedmode.Default ConfigurationNo static addresses are defined. The default mode for an added address is permanent.Command ModeInterface Configuration (VLAN) mode.User Guidelines• There are no user guidelines for this command.5400_CLI.book Page 95 Wednesday, December 17, 2008 4:33 PM
