294 QoS CommandsSyntax• rate-limit rate• no rate-limit• rate — Specifies the maximum of kilobits per second of ingress traffic on a port. (Range: 3.5M –1G )Default ConfigurationThe default configuration is disabled.Command ModeInterface Configuration (Ethernet) mode.User Guidelines• The command can be enabled on a specific port only if port storm-control brodcast enable InterfaceConfiguration command is not enabled on that port.Note: For PowerConnect 5400 devices, the calculated rate includes the 20 bytes of Ethernet framingoverhead (preamble+SFD+IPG).ExampleThe following example limits the rate of the incoming traffic on Ethernet port 1/g15 to 1000kpbs.show qos interfaceThe show qos interface User EXEC mode command displays interface QoS data.Syntax• show qos interface [queuing | shapers | rate-limit] [ethernet interface-number | port-channelnumber]• queuing — Displays the queue's strategy (WRR or EF) and the weight for WRR queues and theCoS to queue map and the EF priority.• shapers — Displays the shaper of the specified interface and the shaper for the queue on thespecified interface.• rate-limit — Displays the rate-limit configuration.• ethernet interface-number — Valid Ethernet port number.• port-channel number — Valid port-channel number.console(config)# interface ethernet 1/g15console(config-if) rate-limit 10005400_CLI.book Page 294 Wednesday, December 17, 2008 4:33 PM
