1182 BigIron RX Series Configuration Guide53-1001810-01Displaying IPv6 MBGP information46Displaying the Active MBGP ConfigurationTo display the active MBGP configuration information contained in the running-config withoutdisplaying the entire running-config, enter the following command at any level of the CLI.Syntax: show ipv6 mbgp configNOTEThis command displays exactly the same information as the show ipv6 bgp config command. Eachcommand displays both the BGP and MBGP configuration commands that are in the running-config.Displaying MBGP neighborsTo view MBGP neighbor information including the values for all the configured parameters, enterthe following command. This display is similar to the show ipv6 bgp neighbor display but hasadditional fields that apply only to MBGP. These fields are shown in bold type in the example andare explained below.NOTEThe display shows all the configured parameters for the neighbor. Only the parameters that havevalues different from their defaults are shown.BigIron RX# show ipv6 mbgp configCurrent BGP configuration:router bgplocal-as 200neighbor 166.1.1.2 remote-as 200address-family ipv6 unicastno neighbor 166.1.1.2 activateexit-address-familyaddress-family ipv6 multicastredistribute connectedredistribute staticneighbor 166.1.1.2 activateexit-address-familyaddress-family ipv6 unicastexit-address-familyend of BGP configuration
