BigIron RX Series Configuration Guide 55553-1001810-01ACL accounting 21Displaying accounting statistics for all ACLsTo display a summary of the number of hits in all ACLs on a Multi-Service device, enter the followingcommand.The display shows the following information.Syntax: show access-list accounting briefDisplaying statistics for an interfaceTo display statistics for an interface, enter commands such as the following.This field... Displays...The IP multicast traffic snooping state The first line of the display indicates whether IP multicast trafficsnooping is enabled or disabled. If enabled, it indicates if the feature isconfigured as passive or active.Collecting ACL accounting summary forShows for which interfaces the ACL accounting information wascollected and whether or not the collection was successful.Int The ID of the interface for which the statistics are being reported.In ACL The ID of the ACL used to filter the incoming traffic on the interface.Total In Hit* The number of hits from incoming traffic processed by all ACL entries(filters) in the ACL. A number is shown for each counter.* The Total In Hit displays the total number of hits for all the ACL entries (or filters) in an ACL. For example, if anACL has five entries and each entry processed matching conditions three times during the last minute, then thetotal Hits for the 1m counter is 15.device(config)#show access-list accounting briefCollecting ACL accounting summary for VE 1 ... Completed successfully.ACL Accounting Summary: (ac = accumulated since accounting started)Int In ACL Total In HitVE 1 111 473963(1s)25540391(1m)87014178(5m)112554569(ac)BigIron RX(config)#show access-list accounting ve 1 inCollecting ACL accounting for VE 1 ... Completed successfully.ACL Accounting Information:Inbound: ACL 1111: deny tcp any anyHit count: (1 sec) 237000 (1 min)12502822(5 min) 87014178 (accum) 995170003: permit ip any anyHit count: (1 sec) 236961 (1 min) 13037569(5 min) 0 (accum) 130375690: deny tcp 1.1.1.0 0.0.0.255 2.2.2.0 0.0.0.255Hit count: (1 sec) 0 (1 min) 0(5 min) 0 (accum) 02: deny udp any anyHit count: (1 sec) 0 (1 min) 0(5 min) 0 (accum) 0
