216 BigIron RX Series Configuration Guide53-1001810-01Displaying IP information7To display detailed IP information for a specific interface, enter a command such as the following.Displaying interface name in SyslogBy default an interface’s slot number (if applicable) and port number are displayed when youdisplay Syslog messages. You can display the name of the interface instead of its number byentering a command such as the following.BigIron RX(config)# ip show-portnameThis command is applied globally to all interfaces on the device.Syntax: [no] ip show-portnameWhen you display the messages in the Syslog, you see the interface name under the Dynamic LogBuffer section. The actual interface number is appended to the interface name. For example, if theinterface name is "lab" and its port number is "2", you see "lab2" displayed as in the example below.Status The link status of the interface. If you have disabled the interface with thedisable command, the entry in the Status field will be “administrativelydown”. Otherwise, the entry in the Status field will be either “up” or “down”.Protocol Whether the interface can provide two-way communication. If the IP addressis configured, and the link status of the interface is up, the entry in theprotocol field will be “up”. Otherwise the entry in the protocol field will be“down”.TABLE 50 CLI display of interface IP configuration information (Continued)This field... Displays...BigIron RX# show ip interface ethernet 1/1Interface Ethernet 1/1port state: UPip address: 192.168.9.51 subnet mask: 255.255.255.0encapsulation: ETHERNET, mtu: 1500, metric: 1directed-broadcast-forwarding: disabledproxy-arp: disabledip arp-age: 10 minutesIp Flow switching is disabledNo Helper Addresses are configured.No inbound ip access-list is setNo outgoing ip access-list is setBigIron RX># show loggingSyslog logging: enabled (0 messages dropped, 0 flushes, 0 overruns)Buffer logging: level ACDMEINW, 3 messages loggedlevel code: A=alert C=critical D=debugging M=emergency E=errorI=informational N=notification W=warningStatic Log Buffer:Dec 15 19:04:14:A:Fan 1, fan on right connector, failedDynamic Log Buffer (50 entries):Dec 15 18:46:17:I:Interface ethernet Lab2, state upDec 15 18:45:15:I:Warm start
