616 BigIron RX Series Configuration Guide53-1001810-01Anycast RP23 Displaying the RP set listTo display the RP set list, enter the following command at any CLI level.Syntax: show ip pim rp-setThis display shows the following information.Displaying multicast neighbor informationTo display information about the device’s PIM neighbors, enter the following command at any CLIlevel.Syntax: show ip pim nbrThis display shows the following information.Table 0.6:This field... Displays...Number of group prefixes The number f PIM Sparse group prefixes for which the RP is responsible.Group prefix Indicates the multicast groups for which the RP listed by the previousfield is a candidate RP.RPs expected/received Indicates how many RPs were expected and received in the latestBootstrap message.RP Indicates the RP number. If there are multiple RPs in the PIM Sparsedomain, a line of information for each of them is listed, and they arenumbered in ascending numerical order.priority The RP priority of the candidate RP. During the election process, thecandidate RP with the highest priority is elected as the RP.age The age (in seconds) of this RP-set.NOTE: If this device is not a BSR, this field contains zero. Only the BSRages the RP-set.BigIron RX(config)#show ip pim rp-setGroup address Static-RP-address Override---------------------------------------------------Access-List 44 99.99.99.5 OnNumber of group prefixes Learnt from BSR: 1Group prefix = 239.255.162.0/24 # RPs expected: 1# RPs received: 1RP 1: 43.43.43.1 priority=0 age=0BigIron RX(config-pim-router)# show ip pim nbrPort Neighbor Holdtime Age UpTimesec sec sece3/8 207.95.8.10 180 60 900Port Neighbor Holdtime Age UpTimesec sec secv1 207.95.6.2 180 60 900
