BigIron RX Series Configuration Guide 43153-1001810-01Displaying VSRP information 15Displaying a summary of VSRP informationTo obtain a summary of VSRP Information, enter the show vsrp brief command. If the command isentered on a VSRP Backup, it displays the following information.BigIron RX# show vsrp briefVLAN VRID ConfPri CurPri P State PeerMacAddruir IpAddress VIP10 10 100 80 P Backup xxxx.db21.11a0 219.33.17.160 NoneWhen the command is entered on a VSRP Master, it displays the following information.BigIron RX# show vsrp briefVLAN VRID ConfPri CurPri P State PeerMacAddr or IpAddress VIP10 10 100 80 P Master Unknown Unknown NoneWhen the command is entered on a Layer 3 VSRP, it displays the following information.BigIron RX# show vsrp briefVLAN VRID ConfPri CurPri P State PeerMacAddr or IpAddress VIPdead-interval The configured value for the dead interval. The dead interval is thenumber of units a Backup waits for a Hello message from the Master forthe VRID before determining that the Master is no longer active (1 unit =100 milliseconds).If the Master does not send a Hello message before the dead intervalexpires, the Backups negotiate (compare priorities) to select a newMaster for the VRID.NOTE: The value is never 0, as it defaults to 3 units.hold-interval The number of units a Backup that intends to become the Master willwait before actually beginning to forward Layer 2 traffic for the VRID (1unit = 100 milliseconds).If the Backup receives a Hello message with a higher priority than itsown before the hold-down interval expires, the Backup remains in theBackup state and does not become the new Master.initial-ttl The number of hops a Hello message can traverse after leaving thedevice before the Hello message is dropped.NOTE: An MRP ring counts as one hop, regardless of the number ofnodes in the ring.next hello sent in The amount of time until the Master’s dead interval expires. If theBackup does not receive a Hello message from the Master by the timethe interval expires, either the IP address listed for the Master willchange to the IP address of the new Master, or this Layer 3 Switch itselfwill become the Master.NOTE: This field applies only when this device is a Backup.master router The IP address of the master router.Member ports The ports in the VRID.Operational ports The member ports that are currently up.Forwarding ports The member ports that are currently in the Forwarding state. Ports thatare forwarding on the Master are listed. Ports on the Standby, which arein the Blocking state, are not listed.Restart ports Lists the ports on which VSRP fast start enabled.TABLE 81 CLI display of VSRP VRID or VLAN information (Continued)This field... Displays...
