1224 BigIron RX Series Configuration Guide53-1001810-01Displaying OSPFv3 information48Displaying OSPFv3 interface informationYou can display a summary of information for all OSPFv3 interfaces or detailed information about aspecified OSPFv3 interface.To display a summary of OSPFv3 interfaces, enter the following command at any CLI level.Syntax: show ipv6 ospf interface [ethernet <port> | loopback <number> | tunnel <number> | ve<number>]The ethernet | loopback | tunnel | ve parameter specifies the interface for which to displayinformation. If you specify an Ethernet interface, also specify the port number associated with theinterface. If you specify a loopback, tunnel, or VE interface, also specify the number associatedwith the interface.Prefix Options An 8-bit field of capabilities that serve as input to various routing calculations:• NU – The prefix is excluded from IPv6 unicast calculations.• LA – The prefix is an IPv6 interface address of the advertising router.• MC – The prefix is included in IPv6 multicast routing calculations.• P – NSSA area prefixes are readvertised at the NSSA area border.Prefix The IPv6 prefix included in the LSA.Intra-area prefix LSAs (Type 9) (Iap) fieldsNumber of Prefix The number of prefixes included in the LSA.Referenced LS Type,Referenced LS IDIdentifies the router-LSA or network-LSA with which the IPv6 address prefixes areassociated.ReferencedAdvertising RouterThe address of the neighboring router that advertised the route.Prefix Options An 8-bit field describing various capabilities associated with the prefix.Metric The cost of using the advertised prefix.Prefix The IPv6 prefix included in the LSA.Number of Prefix The number of prefixes included in the LSA.TABLE 206 OSPFv3 detailed database information fields (Continued)This field... Displays...BigIron RX# show ipv6 ospf interfaceInterface OSPF Status State Areaethe 3/1 upethe 3/2 enabled up DR 0ethe 3/4 disabled downloopback 2 enabled up Loopback 0tunnel 1 disabled downtunnel 2 enabled up P2P 0tunnel 6 up
