Dell PowerEdge M I/O Aggregator Reference Manual

Also see for PowerEdge M IO Aggregator: Command reference guide Getting started guide

Contents

Interfaces | 151CommandHistoryExample Figure 11-26. show interfaces status Command Exampleshow interfaces switchportDisplays only virtual and physical interfaces in Layer 2 mode. This command displays the Layer 2mode interfaces’ IEEE 802.1Q tag status and VLAN membership.Syntax show interfaces switchport [interface | stack-unit unit-id ]ParametersCommand Modes EXECEXEC PrivilegeCommandHistoryVersion 8.3.17.0 Supported on M I/O AggregatorFTOS#show interface statusPort Description Status Speed Duplex VlanTe 0/1 Down Auto Auto --Te 0/2 Down Auto Auto --Te 0/3 Down Auto Auto --Te 0/4 Down Auto Auto --Te 0/5 Down Auto Auto --Te 0/6 Down Auto Auto --Te 0/7 Down Auto Auto --Te 0/8 Up 10000 Mbit Full --Te 0/9 Down Auto Auto --Te 0/10 Down Auto Auto --Te 0/11 Down Auto Auto --Te 0/12 Down Auto Auto --Te 0/13 Down Auto Auto --Te 0/14 Down Auto Auto --Te 0/15 Down Auto Auto --Te 0/16 Up 10000 Mbit Full --FTOS#interface Enter one of the following keywords and slot/port or number information:• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernetfollowed by the slot/port information.• Enter the keyword backup to view the backup interface for this interface.stack-unitunit-id(OPTIONAL) Enter the keyword stack-unit followed by the stack member number.Range: 0 to 5Version 8.3.17.0 Supported on M I/O Aggregator