Control and Monitoring | 41debug cpu-traffic-statsEnable the collection of CPU traffic statistics.Syntax debug cpu-traffic-statsDefaults DisabledCommand Modes EXEC PrivilegeCommandHistoryUsageInformationThis command enables (and disables) the collection of CPU traffic statistics from the time thiscommand is executed (not from system boot). However, excessive traffic received by a CPUautomatically triggers (turns on) the collection of CPU traffic statistics. Use the show configurationlock to view the traffic statistics.If excessive traffic is received by CPU, traffic is rate controlledRelatedCommandsdebug ifm trace-flagsTurn on the IFM internal trace-flags.Syntax debug ifm trace-flags trace-flagsDisable this command using the no debug ifm trace-flags command.ParametersDefaults NoneCommand Modes EXEC PrivilegeCommandHistoryUsageInformationDisable this command using the no debug ifm trace-flags command.Version 8.3.17.0 Supported on M I/O AggregatorNote: This command must be enabled before the show configuration lock command displaystraffic statistics. Dell Force10 recommends disabling debugging (no debugcpu-traffic-stats) after troubleshooting is complete .show configurationlockDisplays the cpu traffic statisticstrace-flag Enter a hexadecimal number representing the trace-flag.Version 8.3.17.0 Supported on M I/O AggregatorNote: Use this command only when you are working directly with a technical supportrepresentative to troubleshoot a problem. Do not use this command unless a technical supportrepresentative instructs you to do so.
