Simple Network Management Protocol (SNMP) and Syslog | 215logging source-interfaceSpecify that the IP address of an interface is the source IP address of Syslog packets sent to the Syslogserver.Syntax logging source-interface interfaceTo disable this command and return to the default setting, use the no logging source-interfacecommand.ParametersDefaults Not configured.Command Modes CONFIGURATIONCommandHistoryUsageInformationSyslog messages contain the IP address of the interface used to egress the router. By configuring thelogging source-interface command, the Syslog packets contain the IP address of the interfaceconfigured.RelatedCommandslogging trapSpecify which messages are logged to the Syslog server based the message severity.Syntax logging trap [level]To return to the default values, use the no logging trap command. To disable logging, use the nologging trap command.ParametersDefaults 6 or informational.Command Modes CONFIGURATIONCommandHistoryRelatedCommandsinterface Enter the following keywords and slot/port or number information:• For a Ten Gigabit Ethernet interface, enter the keyword TenGigabitEthernetfollowed by the slot/port information.• For VLAN interface, enter the keyword vlan followed by a number from 1 to 4094.Version 8.3.17.0 Supported on M I/O AggregatorlogginghostnameEnables the logging to another device.level Indicate a value from 0 to 7 or enter one of the following parameters: emergencies, alerts,critical, errors, warnings, notifications, informational, or debugging.The default is 6.Version 8.3.17.0 Supported on M I/O AggregatorlogginghostnameEnables the logging to another device.logging on Enables logging.