4–Switch Independent PartitioningSwitch Independent Partitioning Setup174 CU0354602-00 LSwitch Independent Partitioning Configuration Parametersand Setup ToolsTable 4-7 identifies which parameters you can configure using each of theavailable management tools.Table 4-7. Switch Independent Partitioning Configuration Parameters and Setup ToolsTools/ConfigurableSwitch IndependentPartitioning ParametersFunctionType aa These changes require system reboot to take effect. Refer to Table 4-6 for available function type options of each partition.Minimum Bandwidth b(Range 0–100%)b For FCoE, the DCBX/ETS negotiated bandwidth overwrites the manually configured bandwidth.Maximum Bandwidth c(Range 0–100%)c For FCoE, the DCBX/ETS negotiated bandwidth overwrites the manually configured bandwidth.Dell System Setup,Lifecycle Controller,or other HII browserYes Yes, configurable Yes, configurableQLogic NIC OptionROM(Hot Key CTRL+Q duringPOST)Yes Yes, configurable Not configurable, read onlyQLogic QConvergeConsoleGUI/CLI for supportedWindows and Linux operatingsystemsYes Yes, configurable but onlyfor NIC partitions, not forstorage (iSCSI/FCoE)partitionsYes, configurable but onlyfor NIC partitions, not forstorage (iSCSI/FCoE)partitionsQLogic Windows DeviceManager–NIC Property PageYes Yes, configurable but onlyfor NIC partitions, not forstorage (iSCSI/FCoE)partitionsYes, configurable but onlyfor NIC partitions, not forstorage (iSCSI/FCoE)partitionsQLogic QConvergeConsolePlug-ins for vSphereYes Yes, configurable but onlyfor NIC partitions, not forstorage (iSCSI/FCoE)partitionsYes, configurable but onlyfor NIC partitions, not forstorage (iSCSI/FCoE)partitions
