3–Adapter Management ApplicationsGeneral Management with QConvergeConsole68 CU0354602-00 L1. Log in to the vSphere Client.2. In the inventory panel, select a server to which to connect.3. Click the Configuration tab.4. In the Hardware panel, click Storage Adapters.5. From the list of available storage adapters, select the iSCSI initiator youwant to configure and then click Properties.6. Click Configure.The General Properties dialog box shows the initiator’s status, defaultname, and alias.7. To enable the initiator, click Enabled.8. (Optional) To change the default iSCSI name for your initiator, type a newname. The name you enter must be worldwide unique and properlyformatted so that all storage devices can recognize the software iSCSIinitiator.9. To save your changes, click OK.Enabling CHAP Authentication with QConvergeConsoleYou can enable CHAP authentication with either the interactive mode ornon-interactive mode of QConvergeConsole CLI. For details on the interactivemode, refer to the QConvergeConsole CLI User’s Guide. For the non-interactivemode of the QConvergeConsole CLI, the following sections describe how toenable CHAP: Configuring CHAP with QConvergeConsole CLI Linking to a CHAP TargetNOTEIf you change the iSCSI name, it is used for new iSCSI sessions.Existing sessions do not use new settings until you log out and log inagain.NOTEFor information on installing and starting the QConvergeConsole GUI, referto the QConvergeConsole GUI Installation Guide (for download instructions,see “Related Materials” on page xii). All procedural information for theQConvergeConsole GUI is covered in the QConvergeConsole GUI’s onlinehelp system.
