3–Adapter Management ApplicationsGeneral Management with QConvergeConsole66 CU0354602-00 Ld. IP_Subnet_Mask [0.0.0.0]: Type the appropriate subnet mask, andthen press ENTER.e. IP_Gateway [0.0.0.0]: Press ENTER to accept the default.f. Enable IPv6 [off]: Press ENTER to accept the default.9. On the options menu that appears, select 3, Save changes and reset HBA(if necessary).10. At the prompt for both ports, type Yes.11. To return to the Converged Network Adapter (CNA) iSCSI Configurationmenu, type P and press ENTER, and then type P and press ENTER again.12. On the Converged Network Adapter (CNA) iSCSI Configuration menu,select 4, Target Configuration.13. Select the same Converged Network Port you selected in Step 6.14. Select 6, Add a Target.15. Complete the interactive list of settings as follows:a. IPv6 Target? [off]: Press ENTER to accept the default.b. TGT_iSCSI_Name [ ]: Type the iSCSI Qualified Name (IQN) of theiSCSI target to connect to and then press ENTER.c. TGT_Port [3260]: Press ENTER to accept the default.d. TGT_TargetIPAddress [0.0.0.0]: Type the IP address of the targetand then press ENTER.16. On the options menu that appears, select 12, Save Target/CHAP Changes.The iSCSI initiator is now configured to connect to the iSCSI target.Configuring the Linux iSCSI InitiatorUse the QConvergeConsole CLI to configure the iSCSI initiator for Linux.To configure a Linux iSCSI initiator:1. Access the QConvergeConsole CLI by typing qaucli in a terminal window.2. On the QConvergeConsole CLI Main Menu, select 2, AdapterConfiguration.3. On the Adapter Type Configuration Selection menu, select 1, CNAConfiguration.4. On the Converged Network Adapter (CNA) Protocol Type Selection menu,select 1, CNA iSCSI Configuration.5. On the Converged Network Adapter (CNA) iSCSI Configuration menu,select 3, Port IP Settings.
