2–Driver Installation and ConfigurationVMware Driver Installation and Configuration42 CU0354602-00 L For PowerShell: vSphere PowerCLIhttp://communities.vmware.com/community/vmtn/vsphere/automationtools/powercliAfter downloading and installing the SDK and the registration script, follow theVMware instructions to unregister the plug-in.For example, the Perl unregister command is:perl registerPlugin.pl --server="127.0.0.1"-username="administrator" --password="password"--key="com.qlogic.QLogicAdapterVIPlugIn" --action="remove"Replace administrator and password with the correct information to log intothe vCenter Server.Enabling and Disabling the Plug-inTo enable or disable the QConvergeConsole VMware vCenter Server plug-in,follow these steps:1. In the vSphere Client window, click Plug-ins and then click ManagePlug-ins.The Plug-in Manager window appears, as shown in Figure 2-17.Figure 2-17. Managing Plug-ins in vSphere Client2. Locate the QConvergeConsole vCenter Server plug-in on the InstalledPlug-ins section of the window.The plug-in’s status (Enabled or Disabled) is displayed in the Status column,as shown in Figure 2-18.NOTEIf the plug-in installation completed successfully, you do not need to enablethe plug-in; it is automatically enabled during installation. You can, however,verify if the plug-in is enabled by using the following procedure.