Denon AVR-2105 Operating Instructions Manual

Also see for AVR-2105: Operating instructions Specifications Operating instructions Service manual Operating instructions

12ENGLISHBefore setting up the system4 Press the SYSTEM SETUP button to enter thesetting.*SYSTEM SET UP3 Turn on the power.Press the Power ON/STANDBY switch (button).ON / STANDBY(Main unit)NOTE: Please make sure the “AUDIO” position ofthe slide switch on the remote control unit.5 Press the ENTER or (down) button to switch to the Auto Setup.NOTE:• Press the SYSTEM SETUP button again to finish system set up. System set up can be finished at any time.The changes to the settings made up to that point are entered.2 Press the Power switch (button).ON OFF(Main unit)• ¢ ONThe power turns on and indicator is light.Set the power switch to this position to turn the power on and off from theincluded remote control unit.• £ OFFThe power turns off and indicator is off.In this position, the power cannot be turned on and off from the remote controlunit.1 Refer to “CONNECTIONS” (pages 5 to 9) and check that all connections are correct.Auto SetupThe Auto Setup function of this unit performs an analysis of the speaker system to permit an appropriateautomatic setting.When performing Auto Setup, a microphone is required for the setup.2 Measurement and setting detailsq Speaker Config.: This sets the speaker connection mode, polarity, and bass reproduction ability.w Delay Time : This sets the optimum delay time from each speaker corresponding to the listeningposition.e Channel Level : This sets the volume that is output from each speaker.NOTE:• A loud test tone is output during the measurement. Please consider this should you be planning nighttimemeasurements, and consider not allowing small children into the listening room at this time.Connecting the microphone for Auto Setup12SELECTS-VIDEO OPTICAL SETUP MICVIDEOV.AUX INPUTL AUDIO RA BSPEAKERSTANDARD5CH / 7CHSTEREODIRECT /STEREOSURROUNDBACKSURROUNDPARAMETERTONEDEFEATSURROUND MODETONE CONTROLAVR-2105AV SURROUND RECEIVERPHONES SELECTConnect the microphone for Auto Setup to theSetup Mic connector on the front panel of theunit.Place the microphone for Auto Setup at theactual listening position which will be at thesame height as your ears. Use a tripod or levelsurface at positioning.Listening position(Remote control unit)(Remote control unit)(Remote control unit)