Denon AVR-2105 Operating Instructions Manual

Also see for AVR-2105: Operating instructions Specifications Operating instructions Service manual Operating instructions

31ENGLISHSELECT1 Turn the SELECT knob to select the surroundmode.1, 3212 Press the SURROUND PARAMETER button.Press and hold in the surround parameter button to select the parameter youwant to set.• The parameters which can be set differ for the different surround modes.(Refer to “Surround Modes and Parameters” on page 32.SURROUNDPARAMETER3 Display the parameter you want to adjust, then turn the SELECT knob to set it.• Operating the surround mode and surround parameters from the main unit‘s panel.• When turned clockwise• When turned counterclockwiseDIRECT STEREO DOLBY PRO LOGIC IIx 5CH/7CH STEREO MONO MOVIEJAZZ CLUB ROCK ARENAVIDEO GAMEMATRIXVIRTUAL SURROUNDDTS NEO:6DIRECT STEREO DOLBY PRO LOGIC IIx 5CH/7CH STEREO MONO MOVIEJAZZ CLUB ROCK ARENAVIDEO GAMEMATRIXVIRTUAL SURROUNDDTS NEO:6To select the surround mode while adjusting the surround parameters, tonedefeat or tone control, press the SURROUND MODE button then operate theselector.SURROUND MODESurround parameters eROOM SIZE:This sets the size of the sound field.There are five settings: “small”, “med.s” (medium-small), “medium”, “med.l” (medium-large) and “large”.“small” recreates a small sound field, “large” a large sound field.EFFECT LEVEL:This sets the strength of the surround effect.The level can be set in 15 steps from 1 to 15.DELAY TIME:In the matrix mode only, the delay time can be set within the range of 0 to 110 ms.The surround mode switches in the followingorder each time the DSP SIMULATION button ispressed:MONO MOVIE ROCK ARENAJAZZ CLUBVIDEO GAMEMATRIXDSP surround simulation1 Select the surround mode for the input channel.2, 3441335• To operate the surround mode and surround parameters from the remote control unit.2 To enter the surround parameter setting mode,press the SURROUND PARAMETER button.• The surround parameter switches in thefollowing order each time the SURROUNDPARAMETER button is pressed for the differentsurround modes.(Remote control unit)(Remote control unit)3(Remote control unit)Select the various parameters.4 Adjust the parameter settings.(Remote control unit)5 Press the ENTER button to finish surround parameter mode.(Remote control unit)(Main unit)(Main unit)(Main unit)NOTE:• When making parameter settings, the display will return to the regular condition several seconds after thelast button was pressed and the setting will be completed.NOTE:• When making parameter settings, the display will return to the regular condition several seconds after thelast button was pressed and the setting will be completed.