Denon AVR-2105 Operating Instructions Manual

Also see for AVR-2105: Operating instructions Specifications Operating instructions Service manual Operating instructions

14ENGLISHCheck of the measurement results1 Select the items.The measurement results of each item can be checkedhere.A.Set SpConf.Ck(Remote control unit)2 Press the ENTER button and display the verification screen.(Remote control unit)[Speaker Config. Check] [Delay Time Check] [Channel Level Check]NOTE:• When measurements have been made using the measurement microphone,speakers with a built-in filter such as subwoofers might be set with a valuethat differs from the physical distance because of the internal electrical delay.3 If the check ends, press the ENTER button again.(Remote control unit)4 Select from the following three items based on themeasurement results.• Store : Set with the checked measurementvalue.• Retry : Perform the measurement again.• Cancel : Cancel the checked measurementvalue.A.Set (Remote control unit)5 When the “Store” is selected, all parameters arestored up and switch to the SUBWOOFER MODEsetting.(Remote control unit)Setting the type of speakers1 Set whether or not speakers are connected and, if so, their size parameters.2 FRONT LARGE2 Press the ENTER or (down) button to enter the settings and switch to theSPEAKER DISTANCE setting.• Set up in function of your speaker systems. Performing this setup optimizes the system.• The composition of the signals output to the different channels and the frequency response are adjustedautomatically according to the combination of speakers actually being used.Center Sp. Front Sp.Front Sp.Listening positionSurround back Sp.SubwooferSurround Sp. Surround Sp.• To select the parameter• ParametersLarge.................Select this when using speakers that have sufficient performance for reproducing bass soundbelow the frequency set for the Crossover Frequency mode.Small .................Select this when using speakers that do not have sufficient performance for reproducing basssound below the frequency set for the Crossover Frequency mode. When this is set, basssound with a frequency below the frequency set for the Crossover Frequency mode is sentto the subwoofer.None .................Select this when no speakers are installed.Yes/No...............Select “Yes” when a subwoofer is installed, “No” when a subwoofer is not installed.2spkrs/1spkr .....Set the number of speakers to be used for the surround back channel.If the subwoofer has sufficient low frequency playback capacity, good sound can be achieved even when“Small” is set for the front, center and surround speakers.(Remote control unit)(Remote control unit)• To select the speaker(Remote control unit)