Denon AVR-2106 Operating Instructions Manual

Also see for AVR-2106: Operating instructions Control protocol Operating instructions Brochure & specs Operating instructions

ENGLISH23ENGLISHBasic Operation Basic Operation• In addition, screen information is displayed in the followingorder when the ON SCREEN button is pressed repeatedly:OSD-1 Input signalOSD-2 Input/outputOSD-3 Auto surround modeOSD-4~10 Tuner preset stationsNOTE:• OSD-3:This is displayed when the auto surround mode is set to“ON” and the input mode is set to “Auto”.It is not displayed when the input mode is set to “Analog”or “EXT. IN”.2 Checking the input signalThe input signal can be checked by pressing the remote controlunit’s ON SCREEN button.SIGNAL:Displays the type of signal (DTS, DOLBY DIGITAL, PCM, etc.).fs:Displays the input signal’s sampling frequency.FORMAT:Displays the input signal’s number of channels.“Number of front channels/Number of surround channels/ LFEon/off”.“SURROUND” is displayed for 2-channel signal sourcesrecorded in Dolby Surround.OFFSET:Displays the dialog normalization offset value.FLAG:Displays the special identification signal recorded in the inputsignal.“MATRIX” is displayed when matrix processing is conductedon the surround back channel, “DISCRETE” is displayed whendiscrete processing is conducted.Not displayed if an identification signal has not been recorded.STANDARD/NIGHTFUNCTION INPUT MODE2 Dialog normalizationThe dialog normalization function is activated automatically whenplaying Dolby Digital program sources.Dialog normalization is a basic function of Dolby Digital whichautomatically normalizes the dialog level (standard level) of thesignals which are recorded at different levels for differentprogram sources, such as DVD, DTV and other future formatsthat will use Dolby Digital.These contents can be verified with the ON SCREEN button.DisplayOFFSET - 4dBThe number indicates the normalization level when thecurrently playing program is normalized to the standard level.Adjusting the audio delay• When watching a DVD or other video source, the picture on themonitor may seem delayed with respect to the sound. In thiscase, adjust the audio delay to delay the sound and synchronizeit with the picture.• The audio delay setting is stored separately for each inputsource.• This adjustment can be performed with the system setup( page 38) or from the remote control unit, as describedbelow.STANDARDCURSORINPUT MODEON SCREENENTERFUNCTIONNight modeWhen listening at night or at lower volumes, the night modeimproves listenability.Press and hold the STANDARD/NIGHT button forseveral seconds to enter the night mode.• Canceling night mode:Press and hold the STANDARD/NIGHT button again.• The night mode only works when playing program sourcesrecorded in Dolby Digital or DTS.