Denon DVD-3910 Operating Instructions Manual

Also see for DVD-3910: Supplementary guide Operating instructions Specifications Specification Operating instructions

Contents

14ENGLISH6 REMOTE CONTROL UNIT2 The DVD-3910 can be controlled from a distance using the included remote control unit (RC-972).(1) Inserting Batteriesq Remove the remote control unit’s rear cover.w Place two R6P/AA batteries in the batterycompartment in the direction indicated by themarks.e Close the rear cover.Cautions On Batteries• Use R6P/AA batteries in this remote control unit.• Replace the batteries with new ones approximatelyonce a year, though this depends on the frequencywith which the remote control unit is used.• If the remote control unit does not operate fromclose to the main unit, replace the batteries withnew ones, even if less than a year has passed.• The included battery is only for verifying operation.Replace it with a new battery as soon as possible.• When inserting the batteries, be careful to doso in the proper direction, following the < and> marks in the remote control unit’s batterycompartment.• To prevent damage or battery fluid leakage:• Do not use a new battery with an old one.• Do not use two different types of batteries.• Do not short-circuit, disassemble, heat ordispose of batteries in flames.• Remove the batteries when not planning to usethe remote control unit for a long period of time.• If the batteries should leak, carefully wipe off thefluid from the inside of the battery compartment,then insert new batteries.(2) Using the Remote Control UnitSELECTHDMI/DVIOPEN/CD/STEREOFORMATNTSC/PAL CLOSE/MULTIPROG/DIRCLEARCALLSEARCH MODEAUDIOSUBTITLEANGLEPAGEMARKERRANDOMDIMMERZOOMPICT ADJ.SETUPMEMORYA-BREPEATSELECTRC-972PURE DIRECTDISPLAYTOP MENURETURNMENUSKIPSLOW/SEARCHPLAYSTILL/PAUSESTOPBACK LIGHTPOWER OFFPOWER ONApprox. 7 meters• When operating the remote control unit,point it at the remote control sensor asshown on the diagram.• The remote control unit can be used from adirect distance of approximately 7 meters.This distance will be shorter, however, ifthere are obstacles in the way or if theremote control unit is not pointed directlyat the remote control sensor.• The remote control unit can be operated ata horizontal angle of up to 30° with respectto the remote control sensor.NOTES:• It may be difficult to operate the remotecontrol unit if the remote control sensor isexposed to direct sunlight or strongartificial light.• Do not press buttons on the main unit andon the remote control unit at the sametime. Doing so will result in malfunction.SELECTHDMI/DVI OPEN/SUPER AUDIOFORMAT NTSC/PAL CLOSECD SETUPPROGRAM/DIRECTCLEARCALLSEARCH MODEAUDIOSUBTITLEANGLEPAGEMARKERRANDOM DIMMERZOOMPICTUREADJUSTSETUP MEMORYA-BREPEATSELECTPURE DIRECTDISPLAYTOP MENURETURNMENUSKIP SLOW/SEARCHPLAYSTILL/PAUSESTOPBACK LIGHTPOWER OFF POWER ONq@1@2@3@5@7@8@9#0#1#3 #2#4@0@4@6!8!9weruio!2!3!5!7!4!6!1!0yt(3) Names and Functions of Remote Control Unit Buttons2 Button not explained here function in the same way as the corresponding buttons on the main unit.q POWER ON/POWER OFF buttons• Press this to switch the power between onand standby.w HDMI/DVI SELECT/FORMAT buttons• Use these to select to use HDMI terminal orDVI terminal, and the format of video signals(480P/576P,720P,1080i).e Number buttons• Use these to input numbers.Use the +10 button to input numbers of 10 orover.Example: To input 25r LIGHT button• Press this to light the opal color button.Press again this to put out light.t ANGLE button• Press this to switch the angle.y TOP MENU button• The top menu stored on the disc is displayed.u Cursor buttons/ENTER button• Use the • and ª cursor buttons to select inthe vertical direction.Use the 0 and 1 cursor buttons to select inthe horizontal direction.Press the ENTER button to select the itemselected with the cursor buttons.i MENU button• The DVD menu stored on the disc isdisplayed.o STOP button (2)!0 STILL/PAUSE button (3)!1 SKIP buttons!2 REPEAT button• Press this to play tracks repeatedly.!3 A-B repeat button (A-B)• Use this to repeat sections between twospecific points.!4 RANDOM button• Press this to play the tracks on the video ormusic CD in random order.!5 MARKER button• Press this to mark places you want to seeagain.!6 SETUP button• Press this to display the default settingscreen.!7 PICTURE ADJUST button• Press this to adjust the picture quality to suityour tastes.!8 OPEN/CLOSE button!9 NTSC/PAL button• Use this to switch the set’s video outputformat (NTSC/PAL).@0 SUPER AUDIO CD SETUP button@1 PROGRAM/DIRECT button• Press this to switch between the normal play,programmed play.@2 CLEAR button• Press this to clear numbers that you haveinput.@3 CALL button• Press this to check the program contents.@4 SEARCH MODE button• Press this to change the search mode to search forgroups or titles, tracks or chapters when selectingsections of discs directly using the number buttons.@5 AUDIO button• For DVDs, press this to switch the audiolanguage. For video CDs, press this to switchthe channel between “STEREO”, “MONOLEFT” and “MONO RIGHT”.@6 SUBTITLE button• Press this to switch the DVD’s subtitlelanguage.@7 DISPLAY button• Press this to display the ON-SCREEN.@8 RETURN button• Press this to return to the previous menuscreen.@9 PLAY button (1)30°30°