Eaton 93PM Installation And Operation Manual

Also see for 93PM IBC-L: User and installation guide Manual Installation and operation manual User and installation guide User and installation guide

Contents

54 Eaton 93PM UPS (400V/480V Four-Wire – 100 kW Frame) Installation and Operation Manual 164000566—Rev 04Figure 14. Removing the Pallet Skids and Supports – Eaton 93PM UPSCabinetMounting Bolts(4 places front)(4 places rear)Pallet SkidSkid Mounting Bolts(4 places front)(4 places rear)Floor Protectors(2 places front)(2 places rear)Right SideCabinet SupportRear CabinetSupportJacking Bolts(2 places front)(2 places rear)Front CabinetSupportCabinetSupport Bolts(2 places ateach corner)Left SideCabinet SupportWARNINGDo not remove or loosen the cabinet mounting or cabinet support bolts until instructed. Failure to follow theseinstructions may result in severe injury or death.4. Loosen, but do not remove, the skid mounting bolts holding the pallet skids to the front and rear supports,and to the left and right side supports.5. If a sidecar is attached to the UPS, loosen, but do not remove, the sidecar skid mounting bolts holding thesidecar pallet skids to the sidecar front and rear supports, and to the left and right supports (see Figure 14and Figure 15).WARNINGRISK OF INSTABILITY. Turning the jacking bolts unevenly may cause the cabinet to become unbalanced. Toprevent tipping the cabinet, raise the cabinet no more than 3 mm (1/8") above the floor (just enough to allow theremoval of the pallet skids). Failure to follow these instructions can result in serious injury or death.UPS System Installation