MGR10 A/B/C - Revision : I (for 7.0 software revision) 314.5 LimitsPress on :To select the Limits menu.Two options are then available , [Meas] which enables limits to be set with reference to themeasured values or [O/C] which enables the open circuit voltage to be limited to either 20mV or 50mV( NFC93050 standard B , C conditions )Meas : Press on [Meas] to call the measurement limits menu. Press on [Alm] to activate or not the audible alarm . Press on [On] to activate the audible signal when measurement result fails Or press on [Off] to cancel the audible alarm . Press on [OK] to go back to the previous page Press on [Max] to set the maximum value Press on [Chg] , lto change the value , then enter the new value in Ohm in using thenumeric keypad . Press on [OK] to enter the value. Press on [OK] to go back to the previous page Press on [Min] to set the minimum value and proceed the same way for the upper limit . Press on [On] to activate the comparison mode Press on [Off] to cancel the comparison mode. Press on [OK] to go back to the previous pageCLELIM.LIMITLimits :Meas O/C Quit
