MGR10 A/B/C - Revision : I (for 7.0 software revision) 576.2.2.3 Interface FunctionsThe interface performs the following functions;SH1, AH1, T5, TE0, L3, LE0, SR1, RL1, PP0, DC1, DT1, C0, E2These have the following meanings :SH1 Source HandshakeThe device can send multiline messages.AH1 Acceptor HandshakeThe device can receive multiline messages.T5 Talker CapabilityThe device; can act as a basic talker; can respond to a serial poll; can perform a talk only mode; unaddresses if MLA sentTE0 Extended Talker CapabilityExtended talker addressing is not implemented.L3 Listener CapabilityThe device; can act as a basic listener; can be set to listen only mode; becomes unaddressed if MTA sentLE0 Extended Listener CapabilityExtended listener addressing is not implementedSR1 Service Request FunctionThe device can asynchronously assert the SRQ line to request the attention of the systemcontroller.RL1 Remote/Local FunctionThe device has full remote/local switching capability. There is no manual switch on theinstrument.PP0 Parallel Poll FunctionThe parallel poll function is not implemented.DC1 Device Clear FunctionThe device may be set to the default state by the appropriate command, and includes a selectivedevice clear.DT1 Device Trigger Function