Eaton Power Xpert 9395P-1200 Installation And Operation Manual

Also see for Power Xpert 9395P-1200: Installation and operation manual

Contents

INSTALLING OPTIONS AND ACCESSORIESEaton Power Xpert 9395P-1200 UPS (1200 kVA, 1200 kW) Installation and Operation Manual P-164000500 Rev 4 www.eaton.com/powerquality5-25.1 Installing an Optional Powerware Hot Sync CAN Bridge CardAs an option, a Powerware Hot Sync Controller Area Network (CAN) Bridge Card,shown in Figure 5‐1, can be installed to provide connectivity for operational modecontrol of a parallel system. In addition, this card can be used to connect optionalsystem monitoring devices, such as a Remote Monitor Panel II, a Relay InterfaceModule II, or a Supervisory Contact Module II to the UPS.Plug-in TerminalBlock J3Figure 5‐1. Powerware Hot Sync CAN Bridge CardNOTE Only one Powerware Hot Sync CAN Bridge Card can be installed in the UPS. Multiple CAN cards arenot supported and will cause system conflicts.To install the card:1. Verify the UPS system is turned off and all power sources are removed. SeeChapter 7, “UPS Operating Instructions,” for shutdown instructions.2. Unfasten the front door latch and swing the door open (see Figure 4‐1).3. Install the Powerware Hot Sync CAN Bridge Card into an open X-Slotcommunication bay on the front of the UPS. See Figure 4‐21 and Figure 4‐27 forX-Slot communication bay locations.To locate the appropriate terminals on the Powerware Hot Sync CAN BridgeCard, see Figure 5‐2 and Table 5‐1.