Installing the Ergonomic WorkstationAttach Leg and Base Support CoversFollow these instructions to attach the base support cover (left and right) to its respective basesupport (left and right).1. Attach the base support cover to the right base support.2. Insert and tighten six Phillips head thread form screws (66714) through the base support cover,securing the cover to the base support as illustrated below. Four of the Phillips head screws arelocated at the bottom of the cover and two at the top end as illustrated below.3. Repeat steps 1 and 2 to secure the left cover to the left base support as illustrated below.Base SupportCoverStep (6x)Step 4. Attach the lift base support cover to the base as shown in the illustration on the following page.wwww.eaton.com/powerquality 11-41 06-2011 Eaton Profile Genesys Dual-Lift Ergonomic Workstation Installation 14