Installing the Ergonomic WorkstationInstall Rear Surface and Trim AssemblyFollow these instructions to install the rear surface and trim assembly.Attach Rear Surface Support BeamFollow these instructions and refer to the illustration below to attach the rear surface support frame.NOTE: This procedure requires a team of two people to align the beam and stabilize it until thefasteners are secure.1. Align the rear surface support beam over the top of the lift column.2. From above the beam, insert four TORX M8x35 flathead screws through the beam into the liftcolumn and tighten. NOTE: Cross-tighten the screws in an X pattern (as shown in the detail viewbelow), being careful not to over tighten.wwww.eaton.com/powerquality 11-41 06-2011 Eaton Profile Genesys Dual-Lift Ergonomic Workstation Installation 20Step See Detail(4x)Detail Shown