Aligning Workstation to the Core4. Connect the lift with connector base to the core via four (4) #1/4-20 screws (53956) and#1/4-20 Kep nuts (18209 ).Step Genesys-Compatible InsideSkin (Fabric, Laminate orSteel)90º Compound CornerShownConnector CoverStep (4x)Step Connector Base(G431A903) Genesys Lift(Shown for Reference Only)5. Install the grommet in the grommet opening in the core as shown below.6. Route cables from the lift through the grommet opening in the core as shown below.7. Install connector cover with four (4) screws (66714) as illustrated below.Step Step (4x)8. Install compatible inside skins.You have now completed the alignment of the workstation to the core.www.eaton.com/powerquality 11-41 06-2011 Eaton Profile Genesys Dual-Lift Ergonomic Workstation Installation 36
