Installing the Ergonomic WorkstationAttach Rear SurfaceFollow these instructions and refer to the illustration below to attach the rear surface to the rearsurface support beam.1. Align the rear surface above the rear surface beam using the flat panel display polesand/or grommet opening to help with alignment.2. From the bottom of the rear surface, insert 17 Phillips head screws (62071) through thesupport beam into the bottom of the surface and tighten.Rear SurfaceRear SurfaceSupport BeamStep (17x)www.eaton.com/powerquality 11-41 06-2011 Eaton Profile Genesys Dual-Lift Ergonomic Workstation Installation 24