Eaton XN-GWBR Series User Manual

6 Application example: XNE gateway with an Allen Bradley PLC6.2 Network configuration152 XI/ON: XNE-GWBR-2ETH-IP 09/2011 MN05002007Z-EN www.eaton.comThe following station is used in this application example:6.2 Network configurationThe XI/ON gateways are delivered with the IP address 192.168.1.1.To achieve this, you have either• to adjust the gateway’s IP address via BootP, DHCP etc. for integrating it into your ownnetwork (for detailed information about the different possibilities for address setting,please read, Chapter 4.5 Address setting, Page 37).or• to change the IP address of the used PC or network interface card (for detailed information,please read the following Chapter 6.3 Changing the IP address of a PC/ network interfacecard, Page 153).Table 62:Example stationModule Data widthProcess in ProcessoutAlignmentGW XNE-GWBR-2ETH-IP0 XN-2AI-I(0/4...20MA) 2 words - word byword1 XN-2DI-24VDC-P 2 bits - bit by bit2 XN-2DO-24VDC-0.5A-P - 2 bits bit by bit3 XN-2AI-THERMO-PI 2 words - word byword4 XN-4DI-24VDC-P 4 bits bit by bit5 empty slot6 XN-1AI-U(-10/0...+10VDC) 1 word - word byword7 XN-2AO-I(0/4...20MA) 2 words word byword8 XN-4DI-24VDC-P 4 bits bit by bit9 XN-1SSI 4 words 4 words word bywordNoteIn order to build up the communication between the XI/ON gateway and a PLC/ PCor a network interface card, both devices have to be hosts in the same network.