Eaton XN-GWBR Series User Manual

4 Technical features4.5 Address setting42 XI/ON: XNE-GWBR-2ETH-IP 09/2011 MN05002007Z-EN www.eaton.com4.5.5 Address setting via BootP-modeThe address setting is carried out by a BootP-server in the network after the start-up of thegateway.In order to activate the BootP-mode, the DIP-switch "MODE" is set to "ON", the address swit-ches 2 0 to 2 7 to address "2" (see Table 6: Combinations for the address-switch settings,Page 38).LED-behaviorDuring it’s start-up, the module waits for the address setting via the DHCP-/BootP-server. Thisis indicated by the red flashing "MS" LED. The LED begins to flash green, as soon as theaddress setting via the server is completed. The station is ready for communication.Figure 26:BootPNoteThe subnet mask as well as the default IP address mask assigned to the gateway bythe BootP-server are stored in the gateway’s non-volatile EEPROM.If the gateway is subsequently switched to another adress-mode, the settings car-ried out via BootP (IP address, subnet mask, etc.) will be taken from the module’sEEPROM.AttentionAfter every change of the address-mode, a voltage reset must be carried out.