Eaton XN300 Manual

Also see for XN300: Manual Instruction manual

33 Analog weigh module XN-322-2DMS-WM33.8 Memory layout263 XN300 slice modules 02/24 MN050002EN Eaton.com0x5061 – 0x8xx6SUB 022 RangeConfigChannel1Measuring range configurationfor channel 1 (AI1)Bit 0-2 GAIN 0x01080: GAIN 1 ( ± 120mV)1: reserved2: reserved3: GAIN 8 ( ± 15mV) (default)4: GAIN 16 ( ± 7.5mV)5: GAIN 32 ( ± 3.75mV)6: GAIN 64 ( ± 1.875mV)Bit 3-15 reserved0x5062 – 0x8xx6SUB 032 MeasuringConfigChannel2Measuring configuration forchannel 2 (AI2)Bit 0-9 Filter depth of ADC 1–1023 (Default= 2)0x010ABit 10 0: SINC4 filter (Default),1: SINC3 filterBit 11-13 Resize mode0: Continuous conversion mode(default)6: System zero-scale calibration7: System full-scale calibrationBit 14, 15 reserved0x5063 – 0x8xx6SUB 042 RangeConfigChannel2Measuring range configurationfor channel 2 (AI2)Bit 0-2 GAIN 0x010C0: GAIN 1 ( ± 120mV)1: reserved2: reserved3: GAIN 8 ( ± 15mV) (default)4: GAIN 16 ( ± 7.5mV)5: GAIN 32 ( ± 3.75mV)6: GAIN 64 ( ± 1.875mV)Bit 3-15 reserved0x5064 – 0x8xx6SUB 054 ZeroScaleChannel1 Scale start value for zero point cali-bration for channel 1 0x010E0x5065 – 0x8xx6SUB 064 FullScaleChannel1 Scale end value for zero point cali-bration for channel 1 0x01120x5066 – 0x8xx6SUB 074 ZeroScaleChannel2 Scale start value for zero point cali-bration for channel 1 0x01160x5067 – 0x8xx6SUB 084 FullScaleChannel2 Scale end value for zero point cali-bration for channel 2 0x011ACANObjectIndexDefaultCANMappingEtherCATObjectIndexSize(byte)Local I/OdescriptionLocal I/Oaddresses