Page 17Chapter 5: Installer Menu MapImportant: The defaults listed below enable the control unit to comply with EN50131requirements. If you change those settings, the installation may no longer comply. If thecontrol unit does not comply with EN50131, you must remove any labelling that indicatescompliance.Some options are not always visible as the relevant hardware is not fitted, or notapplicable to the control unit type.MENU Option Factory Default Notes1 Detectors/DevicesDetectors Add/Del Detectors Zone nnn...Delete allProgram Zones Zone 000...Name “Zone nnn”Type Not usedPartitions None Visible only in a partitioned system andwhen zones have a type other than“Not Used”.Attributes All "off", except Supervision Visible when zone is given a type otherthan “Not Used”.Some attributes are only available onparticular zone types.Double Knock does not comply withEN51031.Masking must be enabled in SystemOptions.On-boardKeypadHome Key Action SetHot Key Action Not UsedAudible Keys EnabledRadioKeypadsi-rk01Add/Del Radio KpdEdit Keypads Radio Kpd 01...Name “Radio Kpd 0n”Partitions Partition 1 Visible only in a partitioned system.Key A Name: “Key A”Setting: Partition 1 Full SetOR Full Set in a Part SettingSystemKey B Name: “Key B”Setting: Partition 2 Full SetOR Part Set B in a Part SettingSystemKey C Name: “Key C”Setting: Partition 3 Full SetOR Part Set C in a Part SettingSystemKey D Name: “Key D”Setting: Partition 4 Full SetOR Part Set D in a Part SettingSystemExternalSirensAdd/Del SirenEdit Siren Radio SRN 01...Name “Radio SRN 0n”Partitions Partition 01 Visible only in a partitioned system.
