Eaton i-on style Engineering Manual

Also see for i-on Style: Guide

Contents

Communications MenuPage 89Table 11: Speech Dialler CommandsFunction KeyListen – silence any internal sounders and activate theon-board microphone to hear any noise within therange of the microphone. The control unit automaticallyswitches to listen mode after the message has beenplayed six times1Speak – silence any internal sounders and activate theon-board loudspeaker to speak to anyone at thepremises. Note: Speak and Listen modes cannotoperate at the same time.2Switch between Speak and Listen modes *Play the message again 3End this call and let the control unit contact the nextnominated person for this alarm.5Clear down and do not call any of the other nominatedpersons for this alarm.9Note that when the called party answers a speech dialler call, there could be a six-seconddelay before the control unit starts playing the home message.Call ModeThis option enables or disables the speech dialler feature.MessagesUse this option to record the speech messages you wish the speech dialler to use.There are five messages slots available: The Home Message and Messages 1 to 4. Thecontrol unit can record up to ten seconds of speech for the Home message, and up to fiveseconds of speech for each of the alarm messages. Within each message, you can useany of the following options:Record MessagePress  to start recording. The control unit starts recording from its built-inmicrophone. The display shows a progress bar indicating how long you have left torecord. Press  to end recording.Play MessagePress  to play back the message.Delete MessagePress  to delete the message. When the display asks “Delete Message?” press .TriggersFor each Message 1-4, specify the event category that you want to associate with themessage. You can choose any one of the following:Fire Alarm (see page 40)Hold Up Alarm (see page 40)Burglar Alarm (see page 40)Technical Alarm (see page 41)Tampers (see page 41)Mains Fail (see A/C Fail, page 41)