Eaton i-on style Engineering Manual

Also see for i-on Style: Guide

Contents

Detectors/Devices MenuPage 2724 Hour Alarm - 24 (04)Activating this zone while the system (or partition) is unset causes an internal alarm(internal sounders only). Activating this zone while the system (or partition) is setcauses an alarm from internal and external sounders.Final Exit – FE (05)Zones of this type must be the last detector to be activated on exit, or the first to beactivated on entry. You can use zones of this type to complete the setting of thesystem or partition, or to start the entry procedure. See page 49 to set the exit modetype.Note: If you give a Final Exit zone any of the Part Set attributes, you can programthat zone to behave like a Normal Alarm zone if the user part sets the system. Seepage 55.Entry Route – ER (06)Use this zone type for detectors sited between the Final Exit door/detector and thelocation where the system is set/unset. If the entry/exit timer is running when an EntryRoute zone is triggered, no alarm occurs until the entry/exit timer expires.Note: If you give an Entry Route zone one of the Part Set attributes, you canprogram that zone to behave like a Final Exit zone if the user part sets the system.See page 55.Technical Alarm –TA (07)Use this zone type when you want to monitor equipment, for example a freezer,without raising a full alarm. If a Technical Alarm zone is activated, the control unitlogs the event, generates a fault condition, and (if the control unit is correctlyprogrammed, see page 80) starts communication.If the technical alarm occurs while the system is set, the system makes no audiblealarm. When a user unsets the system, the display shows an alert.If a Technical Alarm zone is activated while the system is unset, the system starts analert immediately and gives a brief tone from the control unit every few seconds.When a user enters a valid access code, the control unit stops the tone and displaysthe zone causing the alarm.When the user acknowledges the alert by pressing , the control unit resets thetechnical alarm ready for the next event.Note that a tamper on a Technical Alarm zone when the system is unset will causean internal alarm.Key Switch Moment. – KSM (08)Use this zone type to connect a momentary keyswitch to a single zone.In a part-setting system, the keyswitch can full set or unset.In a partitioned system, you can allocate the keyswitch to one or more partitions.Each time a user operates the keyswitch, the control unit changes the current setstate.Key Switch Latched – KSL (09)Use this zone type to connect a fixed position keyswitch to a single zone.In a part-setting system, the keyswitch can full set or unset. As with momentarykeyswitches, you can allocate the zone to one or more partitions (see above).When the user opens the keyswitch contacts, the control unit sets the allocatedpartition. When the user closes the contacts, the control unit unsets the allocatedpartition.