Fancom Lumina 35 Installation Manual

Lumina 35 System24SYSTEM → SYSTEM → tab page SharingShare animal data Setting for sending or receiving animal data. The control computers in the network canshare data. In this way the animal data only has to be entered once, at the sender.From computer number Setting of the control computer number of the sender that is used for sharing animaldata. When no computer number is entered the control computer will act as sender.House /Section Setting of the house / section number of the sender that is used for sharing animal data.The house / section number is additional to the computer number.The set data and the operating program in the control computer can be transferred to an SD-card. This data canbe copied back onto the control computer from the SD-card. This must only be performed by an authorisedinstaller, except when backups are made.Place the SD-card in the SD holder on the FUNC (CPU).SYSTEM → SD Card MenuBackup data Backup data writes all the data set in the control computer to the SD-card (type .FBU).A service engineer may require this data so the settings can be checked on a differentcontrol computer.Restore data Restore data re-loads saved data from the SD-card back onto the control computer(type .FBU).Data saved on one control computer can only be loaded into another controlcomputer if both computers are of the same type. In addition, the set controlcomputer numbers must be identical. If both these conditions are not met,loading will fail.Backup FUNC Backup FUNC writes a copy of the operating system (type .FIN) from the controlcomputer to the SD-card.