Fancom Lumina 35 Installation Manual

Lumina 35 Installer46INSTALLER → CLOCKS → LIGHT → tab page ControlControl on* Setting of the way in which light is controlled. This option is only available if lightmeasurement=YES has been selected at light clocks.• LUX: If you want to control the light using a light sensor, select LUX. The lightclock will adjust the light intensity to the measured light intensity.• PERC: If the lighting is not to be controlled using the connected sensor, selectPERC. The data from the light sensor will only be used for readout purposes.Light input* Setting of the input address (analog input) to which the light sensor used isconnected.This option is only available if on HOUSE SETUP → tab page Clocks option lightmeasurement=YES was selected.Light output Setting of the analog output address used to control the light intensity in percentages.Analog type Setting indicating the analog control typeReaction speed* Setting of the reaction speed of the light sensor that controls light intensity if themeasured light level changes (FAST, NORMAL or SLOW).Relay off below Setting of the threshold value below which the relay output deactivates the lighting ifcontrol is based on a percentage (Dim). This prevents an insufficient reaction fromthe lighting below a certain percentage (flickering).The control computer can register digital inputs. These registration inputs can be used to register units (forexample water).The unit is registered in the form of pulse values (counts) or contact. The control computer adds up the number ofcounts or measures the active time and converts the time into a measured unit.INSTALLER → REGISTRATIONDescription Setting of the name of the function.