Lumina 35 Installer41INSTALLER → HEAT COOL HUM → tab page HeatDescription Setting of the name of the function.Temp. Inputs Setting the addresses of the analog inputs. If the temperature sensors have not beenassigned, the control computer will use the house temperature.Control Setting of the heating control type: LINEAR or RELAY.Output address Setting of the analog output address (choice LINEAR control) or relay output address(choice RELAY control).Relay type Setting of the type of relay control (ON/OFF / Modulating).Analog type* Setting indicating the analog control typePrecontrol Setting indicating if the heat demand should be transmitted to a central boiler control(precontrol).INSTALLER, HEAT COOL HUM, tab page OptiSecBand Setting of the maximum correction (Band). The control computer can increase thesetpoint heating until this equals the setpoint house temperature.

Fancom Lumina 35 Installation Manual