CHAPTER 3: INSTALLATION SET UP CYBERSENTRY AND CHANGE DEFAULT PASSWORDC60 BREAKER PROTECTION SYSTEM – INSTRUCTION MANUAL 3-693Figure 3-71: Quick Connect window for Ethernet connection2. Select the Ethernet interface and enter the IP address assigned to the C60, then click the Connect button. TheEnerVista UR Setup software creates a site named “Quick Connect” with a corresponding device also named "QuickConnect" and displays them in the Online Window.3. Expand the sections to view data directly from the C60 device. Use the Device Setup button to change the site name.Each time that the EnerVista software is initialized, click the Quick Connect button to establish direct communications tothe C60. This ensures that configuration of the EnerVista UR Setup software matches the C60 model number.3.9 Set up CyberSentry and change default passwordIf and when first using CyberSentry security, use the following procedure for set up.1. Log in to the relay as Administrator by using the VALUE keys on the front panel or through EnerVista connected serially(so that no IP address is required). If logging in through EnerVista choose Device authentication (see figure). Enter thedefault password "ChangeMe1#". Note that the "Lock relay" setting needs to be disabled in the Security > Supervisorymenu. When this setting is disabled, configuration and firmware upgrade are possible. By default, this setting isdisabled.2. Enable the Supervisor role if you have a need for it.3. Make any required changes in configuration, such as setting a valid IP address for communication over Ethernet.4. Log out of the Administrator account by choosing None.Next, device or server authentication can be chosen on the login screen, but the choice is available only in EnerVista. UseDevice authentication to log in using the five pre-configured roles (Administrator, Supervisor, Engineer, Operator, Observer,or Administrator and Supervisor when Device authentication is disabled). When using a serial connection, only Deviceauthentication is supported. When Server authentication is required, characteristics for communication with a RADIUSserver must be configured on the UR. This is possible only through the EnerVista software. The RADIUS server itself alsomust be configured. At the end of this instruction manual, the appendix called RADIUS Server Configuration gives anexample of how to set up a simple RADIUS server. Once both the RADIUS server and the parameters for connecting the URto the server have been configured, you can choose Server authentication on the login screen of EnerVista.
