9-12 C60 BREAKER PROTECTION SYSTEM – INSTRUCTION MANUALBACK UP AND RESTORE SETTINGS CHAPTER 9: MAINTENANCE94. Manually copy the remaining settings, outlined as follows.To restore settings from an IID file using EnerVista software:1. In Windows, make a copy the IID file with a cid extension.2. Connect to the device in the Online Window area.3. In the Offline Window area, right-click Devices and select Import Devices from SCD.Figure 9-10: Importing an SCD or CID file4. Navigate to and select the file with .cid extension. When prompted, enter a file name to give to an intermediate URSfile. The URS file is added to the Offline Window area.5. Drag the imported file in the Offline Window to the device in the Online Window. Note that the RELAY SETTINGS valuealso is written to a device, and the accepting relay is put into "Programmed" or "Not Programmed" mode asconfigured in the offline file.6. Manually copy the remaining settings, outlined as follows.To restore settings from an IID using SFTP:1. In Windows, make a copy the IID file with a cid extension.2. On a computer on the same subnetwork as the UR device, open a SFTP client application, such as WinSCP. Note thatTFTP cannot be used here.3. Use the device's IP address as the host name.4. If the device has the CyberSentry option, use the User Name of "Administrator" or "Engineer", and the passwordprogrammed for the selected role. The default password is "ChangeMe1#" (without quotation marks).5. If the device does not have the CyberSentry option, use the User Name of "Setting", and the password programmed forthe Setting role. The default password is "ChangeMe1#" (without quotation marks).6. Upload the backup file copy with the CID extension. WinSCP uses drag-and-drop or copy-and-paste for this.7. Manually copy the remaining settings, outlined as follows.To manually copy remaining settings:1. Settings listed in section 4.1.2 Settings Files are not transferred to the UR device with settings files. Enter themmanually either via the front panel or via EnerVista UR Setup software. The values that these settings had at the timethe backup was created are contained within the backup file, accessed through EnerVista UR Setup software.To restore the list of sites and devices from an Environment backup:1. In EnerVista, click File > Environment > Restore. A window opens.2. Select the .ENV file to restore.
