Project Waypoint PageEnter the distance, bearing, and units to projectthe new waypoint.BearingDistanceUnits5. To change the units of measure, highlight nmand press ENTER. Highlight the desired unitsin the list and press ENTER.6. Make any other desired changes to thenew waypoint data (such as the name orsymbol), then press QUIT or PAGE to exit theinformation page.Deleting WaypointsYou can delete individual waypoints or all waypointsthat have a particular symbol.NOTE: Once a waypoint is deleted, it cannotbe recovered from the unit. Back up importantwaypoints to a computer using the optionalPC cable and interface software, such asMapSource, or write them down by hand.To delete a waypoint:1. Open the waypoint’s information page.2. Highlight Delete and press ENTER.To delete waypoints by symbol:1. Open the Waypoints find category and pressMENU.2. Highlight Delete… and press ENTER.3. Highlight the symbol of the waypoint you wantto delete and press ENTER.4. Highlight Yes and press ENTER to confirm.Choose No or press QUIT to exit withoutdeleting.76CS Plus Owner’s Manual 29BASIC OPERATION > C REATING AND USING WAYPOINTS190-00507-00_0A.indd 29 2/14/2005 3:33:23 PM
