Viewing PointsYou can scroll through a recorded elevation or pres-sure profile to view data for any point along the plot.As the crosshairs move across the profile, the statuswindow at the bottom of page changes to display thedate, time, and altitude or pressure for the point at thecrosshairs. You can then view the location at whichthe plot information was recorded on a map.To view points:1. Display the plot and press the Rocker key Leftor Right to show the red crosshairs.2. Press the Rocker key Right or Left to scrollthe crosshairs across the profile.CrosshairsTime, Date,and Pressure atCrosshairsIf you are viewing points on the Elevation Plot, pressENTER to view the location of the crosshairs on themap. Press PAGE or QUIT to close the map.Resetting the DataYou can reset the elevation data and the maximum el-evation data using the Reset page.To reset the elevation data:1. Open the Altimeter or Position Data page andpress MENU. Highlight Reset… and pressENTER.2. The Reset page opens. Highlight the item youwant to reset and press ENTER to place acheck mark in the box.3. To reset the information you selected, highlightApply and press ENTER.Setting Up the AltimeterPress MENU, select Altimeter Setup, and pressENTER to setup the altimeter. You can turn on AutoCalibration and enable a fixed or variable elevationfor the Barometer Mode.64 76CS Plus Owner’s ManualADDITIONAL FEATURES > U SING THE ALTIMETER190-00507-00_0A.indd 64 2/14/2005 3:33:40 PM
